Switching

Wondering if anyone has ever had a problem clearing vty lines. I've done it a million times, with success. But now I have a few devices that have some "hung" sessions. I try to clear them, the command is accepted, but the connection is still there...

Hi,I just had a C2950G-24-EI drop of the network. When I visited the switch, all port LEDs were constant Amber, including the Gigabit ethernet and the System LED was alternating between amber and green.I rebooted the switch and it came up fine, but ...

We plan to deploy a Cisco Secure ACS for the company. We are not sure if to put it behind of the firewall or in the DMZ zone. Does anyone have similar experience? Thx in advance!

I have been looking up Documentation on the NM-ESW-16 module and the Doc's I've read indicated that it is compatible with the 2811 router but when I drill down and try to find specific examples of how to use this module, all I keep running into is do...

According to some 2950 config guide there is a limitation that only 1 (one) destination port for SPAN session can exist. This limitation does not included in every config guide for 2950. But in "Configuring guideline" section always referred ~~~~~~~~...

I hear people mention this, what exactly is it ?

When trying to configure a service policy on a VLAN interface it comes back withSwitch(config-if)#service-policy input TESTMaster SVI send all failed for interface Vlan310, cmd = 38Service Policy attachment failedSwitch(config-if)#Switch is a 3750 st...

Hi all, is it possible to do this ? by natting to 2 internal ports, or would i need 2 public ip's

Hi all, if I have a vpn router c1750 behind my soho837 dsl router, but I only have 1 public ip which is on my dsl router, can I use NAT to nat the ports to the vpn connection on my internal vpn router ?

Hi All,I have Catalyst 3750 which operates as L3 switch.8 routed VLANs 10.0.111.0/27 are configured on it.All these VLANs were created for different types of guest: WiFi, wired and so on. ACLs on Catalyst 3750 protect my LAN from guests and also prot...

Any body who knows if a update of Image from 12.1.13-AE1 to 12.2.22-AE could solve a problem with lost connection for some workstations.

HiI have a doubt with a particular scenario.Imagine we have 2 central Switches that act as STP root for several other switches in the network. These two Catalyst have 4 supervisors for redundancy matters, which connect to each other using their 4 Gig...

Is the flexwan module part number WS-X6182-2PA supported in WS-SUP720 BASE? or do I need to buy an enahanced FlexWan,?

What command do I need to use if now I am using Cisco IOS...The command on CatOs is the following:set port qos 1/1-48 trust-device ciscoipphoneNow what command does the same on IOS?