Dear all,
I'm planning to connect 5 campus locations which are close to 350 meters from my 4507R-E core.
My plan is to lay single mode fiber to the core, my questions are.
1. Planning to buy Ws-X4606-X2-E, in this module do i need to buy X2-10Gb modules
to terminate the fibers or is it included.
2. If i have to buy these X2-10Gb modules which one should i use to run over single mode fiber
as i have told my distance will be 300 to 350 meters.
3. at the remote office site im planning to buy 3750-E to connect the X2-10Gb but exactly which X2
model should i buy
4. if iwant to stack a 3750-E and an ordinary 3750, an ordinary stack cable will do the job?
I will rate all the posts.
Regards
BS.