9600 supervisor issue - Help

[carl_townshend]

Hi All

We are just looking at configuring our new Cisco 9600 switches, we have noticed that the supervisor card in slot 4 is showing as status provisioned and when I do show redundancy its showing in simplex mode.

If I swap the sups around then they both work in slot 3, would this indicate an issue with slot 4?

cheers

[balaji.bandi]

Can you post -  show redun states

we only see simplex mode, when it move from active to standby other one failed.

if both working Mode=duplex

[carl_townshend]

I think it’s ok now, my colleague has configured stackwise but not joined them, so I think this is normal 

[balaji.bandi]

Good to know all ok..thank you for the feedback.