Hi everyone,
I need some help from the community. I was configuring a home lab with an AS2509-RJ access server 4 router and 4 switches. The AS start acting up a couple of days ago when I couldn't switch from the devices anymore. I had console access via Putty and I was able to change from R1 to R3 to SW4, etc then once I get access to the first device I couldn't change anymore. I decided to erase startup-config and reload and start from scratch...but it never happened. After reload it didn't come back, it got stuck during boot up. I don't know what to do next. I'm not sure if ios image needs to be loaded. Any help will be greatly appreciated. Here is the message
System Bootstrap, Version 11.0(10c)XB1, PLATFORM SPECIFIC RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1997 by cisco Systems
2500 processor with 14336 Kbytes of main memory
%SYS-4-CONFIG_NEWER: Configurations from version 12.1 may not be correctly understood.
F3: 11001092+155500+740408 at 0x3000060
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-IS-L), Version 12.1(22c), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Thu 01-Apr-04 18:21 by pwade
Image text-base: 0x030594F0, data-base: 0x00001000
cisco AS2509-RJ (68030) processor (revision K) with 14336K/2048K bytes of memory.
Processor board ID 25180886, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
8 terminal line(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read ONLY)
00:00:07: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up
00:00:07: %LINK-3-UPDOWN: Interface Serial0, changed state to down
00:00:19: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state to down
00:00:23: %SYS-5-CONFIG_I: Configured from memory by console
00:00:23: %LINK-5-CHANGED: Interface Ethernet0, changed state to administratively down
00:00:26: %LINK-5-CHANGED: Interface Serial0, changed state to administratively down
00:00:29: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down
00:01:07: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-IS-L), Version 12.1(22c), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Thu 01-Apr-04 18:21 by pwade
