Hello,
I need assistance to fix a problem with an ASA 5505. Device boots to rommon #0> and stays there.
The complete boot record follows:
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
CISCO SYSTEMS
Embedded BIOS Version 1.0(12)13 08/28/08 15:50:37.45
Low Memory: 632 KB
High Memory: 507 MB
PCI Device Table.
Bus Dev Func VendID DevID Class Irq
00 01 00 1022 2080 Host Bridge
00 01 02 1022 2082 Chipset En/Decrypt 11
00 0C 00 1148 4320 Ethernet 11
00 0D 00 177D 0003 Network En/Decrypt 10
00 0F 00 1022 2090 ISA Bridge
00 0F 02 1022 2092 IDE Controller
00 0F 03 1022 2093 Audio 10
00 0F 04 1022 2094 Serial Bus 9
00 0F 05 1022 2095 Serial Bus 9
Evaluating BIOS Options ...
Launch BIOS Extension to setup ROMMON
Cisco Systems ROMMON Version (1.0(12)13) #0: Thu Aug 28 15:55:27 PDT 2008
i2c_read_word_w_wait() error, slot = 0x0, device = 0x64, address = 134 byte coun
t = 2. Reason: I2C_UNPOPULATED_ERROR
Platform ASA5505
Ethernet0/0
i2c_write_byte_w_wait() error, slot = 0x0, device = 0x64, address = 128 byte cou
nt = 1. Reason: I2C_UNPOPULATED_ERROR
esw_reg_read: i2c_write_byte_w_wait(0) returned 0x6
Ethernet port 0 could not be initialized.
Default Interface number-0 Not Up
Use ? for help.
rommon #0>
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
I cannot access the device via web browser nor can I get into device root ciscoasa(config)# prompt.
Thanks in advance.
Enrique S.
I have tried the set options as suggested in https://learningnetwork.cisco.com/thread/34184. Values are saved until next boot. But device ports cannot be initialized. ASA is no longer in warranty. Will a working bin image copied from an inserted flash help? Will it help too to check / format disk:0 ?
