Auto QoS: 9200 and 9400 switchse

[jaheshkhan]

client have 3 IDF that are connected to core switch? IDFs are 9200 switches. core switch is 9400 .

May I know how to apply Auto Qos commands here? how about it should apply on uplink ports?

what I remember its just one command .

if anybody familiar may I know the template to apply there on access and link aggregation trunk uplink ports on IDF and core switch

[balaji.bandi]

yes correct check below configuration guide :

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9200/software/release/16-9/command_reference/b_169_9200_cr/b_169_9200_cr_chapter_01010.html

Also consider using this command - qos queue-softmax-multipler 1200

If you looking to deploy end to end need to apply where it required depends on the requirement.