I have applied 'auto qos voip cisco-phone' on the access port connected to a cisco phone.
Switch is connected to uplink switch by etherchannel, with etherchannel configured as L3 interface.
On all physical interfaces of etherchannel 'auto qos trust' is configured and same is done on the uplink switch.
However i do not see packets matching on priority qeue on either switch interfaces.
Am i doing something wrong? Both the switches are 3850 on 03.06.08
One of the uplink ports
TenGigabitEthernet1/1/1
Service-policy output: AutoQos-4.0-Output-Policy
queue stats for all priority classes:
Queueing
priority level 1
(total drops) 0
(bytes output) 54830820
Class-map: AutoQos-4.0-Output-Priority-Queue (match-any)
0 packets
Match: dscp cs4 (32) cs5 (40) ef (46)
0 packets, 0 bytes
5 minute rate 0 bps
Match: cos 5
0 packets, 0 bytes
5 minute rate 0 bps
Priority: 30% (300000 kbps), burst bytes 7500000,
Priority Level: 1 Port connected to cisco phone
GigabitEthernet7/0/48
Service-policy input: AutoQos-4.0-CiscoPhone-Input-Policy
Class-map: AutoQos-4.0-Voip-Data-CiscoPhone-Class (match-any)
115416 packets
Match: cos 5
0 packets, 0 bytes
5 minute rate 0 bps
QoS Set
dscp ef
police:
cir 128000 bps, bc 8000 bytes
conformed 25680072 bytes; actions:
transmit
exceeded 0 bytes; actions:
set-dscp-transmit dscp table policed-dscp
conformed 27000 bps, exceeded 0000 bps
