Switching

                   Find the enclosed diagram and give us solution.when we try to connect it is not working.

Greetings all,I`ve a strange issue I can`t fathom, I could do with a little help on please.I`ve setup a few connected Cisco switches with VLANS which have been working as expected for the last year. However, I`ve made some recent additions which don`...

I am still new to cisco routers.......and routingI have a syslog server running on my lan with the ip address of 192.168.0.1The ATT 3801hgv router ip address is 192.168.1.254I am trying to forward the syslog messages to my syslog serverI am using a c...

HiWe purchased an RV220W and would like to configure two VLAN's, one containing the wired ports and one WLAN (primary) and the second containing only a WLAN (guest). We have tried to do this before and somehow managed to render the router useless and...

Hi all,In a given environement (2x 5k and 2xN7K) with fabricpath we had the following output:Xxxxxxxxxxx-hostname# show fabricpath isis adjacencyFabricpath IS-IS domain: default Fabricpath IS-IS adjacency database:System ID SNPA Level State Hold Time...

Hi,There are certain servers/apps which support multiple ip's under single card interface  on the server appliance side.In this case, is it feasible to configure a single switch port to support multiple ( eg. two vlans ) on the same switch port.How c...

Hi There,today during an initial configuration of a network i came to a simple issue. supposed to be simple :-)When i set up a trunk between ME3600X and 4500X i failed.ME is not supporting "desirable" and so in need to set up the trunk in mode "on" t...

Hello, We had a SPAN session in our Cat6509E (VSS) where we mirrored 3 vlan.  After we changed that SPAN session and we left only one VLAN, we noticed  swith was still mirroring old vlan traffic. Is typical that behaviour?  Can we reset it?Best regar...

Hi,I am using 3750 and purchased new 3750X L3 switch. I m going to do HSRP between that two switches. Please suggest which firmware do i use?. Which is stable version? Thanks,sampath

I am trying to upgrade a link between two routers from a pair of bundles T1's to a ethernet copper link.  I have tried 3 different times and it always fails and I am at a loss to explain why.  I am assuming it has something to do with the VRFs that a...

We are the aggregation and internet access portal for school districts in our area.  We also offer hosting services, etc.  Right now everything connects directly into a 6513 core.  Traffic between districts and the datacenter is routed through a FWSM...

Hi,We planning for the VSS implementation, can i proceed further with my estimates,Powering on with primary switch fully configured and secondary zero config oly with VSL configuration.Would my VSS intiated succesfully ?? pls share your annotations.T...

Good afternoon -We have two 3750X switches stacked using Stackwise. From a downstream device we have a running ping going across the stack - as part of our testing we have pulled the power cables to simulate the loss of the master switch in the stack...

Good morning,I've just reset a Cisco 3750 Switch back to factory defaults one thing i noticed was StackMGR come up saying %STACKMGR-4-SWITCH_ADDED:SWITCH 1 has been ADDED to the stack. why am i getting the above message. please log taken from reboote...