Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have a 2911 CUBE that was configured to use NexVortex for a SIP ITSP, and has worked for years. Suddenly, outbound calls ceased to work. Inbound calling works fine. NXVX requires authentication in the SIP invite. What's happening is the ...
Hi Everyone,So, I have a pair of Cisco Firepower 4110 firewalls in an HA active/standby configuration, and a pair of edge routers with HSRP. I needed four 10GB ports to create a L2 domain for all of the devices to be connected together. So, I stack...
Hi Everyone,We're currently running a pair of routed FTD 4410 units in a HA-Pair. We've purchased two new 3140 units to replace the 4110's. With regards to swapping the units out, here is what I'm thinking:Add new units to FMCAssign ACP to new prima...
Hi Everyone, Posting here in a last ditch effort. Any help is greatly appreciated. Cisco TAC, despite the hefty fee we pay, is very unresponsive. We have two Firepower 4110 units in an HA Active/Standby cluster. The "outside" interfaces of these t...
Hi,
We recently deployed the RDP agent to all of our Windows systems (server and workstation). We were excited when logging in locally to have the “Remember Me” option. It worked fine for the first week or two, but no longer works. The box is chec...
Thanks All! I'm rating your suggestions/answers as helpful, as they are definitely pertinent to resolving this issue in most cases. Our case turned out to be network related. And it was incredibly strange and hard to diagnose. I worked on it til ...
I wanted to share that, after receiving the 407, the CUBE sends an ACK, then NexVortex receives nothing else. Debug ccsip messages shows another invite from the CUBE containing actual registration info. But when I do a PCAP from the upstream switch,...
I've attached a really bad diagram I have a better one in Visio, but it has a bunch of other stuff on it too.Each device is connected to a TenGigabitEthernet port. ASR 1 to Ten1/0/1, Firepower 1 to Ten1/0/2, ASR 2 to Ten2/0/1 Firepower 2 to Ten2...
Marius,Thank you! So, it's ok to restore using a backup from a different FTD model? I'm assuming as long as the code version is the same, it's ok? Also, is it ok to do this all in the same FMC? We only have one FMC, and it's virtual.Thanks,-Mike
I understand what you’re saying, however there is no L2VPN in use at all. All of this, the dual devices and everything, is contained within one single datacenter. Our outside BGP peers are with our carrier on a government network.
