Switching

Hi,I'm pretty new to all this and have read a lot. My situation is as follows:I've got a 3750 12 port SFP port switch which connects to 48 ethernetport + 4SFP port switches through a trunk (they are also all trunked between each other and then each o...

I want to see the SSH managent interface on my customer's SGE2010 to see if it's at all useful - like IOS CLI maybe or not?I'm having trouble getting SSH management access configured via the GUI - I'm a old CLI junkie and poorly thought out GUIs like...

Hello Everyone,I have a perculiar issue occuring on a Cisco network comprised of legacy switching equipment:Core Switches          2 x 3550-12GEdge Switches         5 x 2950G-48-EI Gigastacked split across the two cores via fibreI have servers connec...

I have a router with two T1 connections going to different customers.  I need to direct all the traffic from one T1 to VALN 100 and from other to VLAN 200.  How would I accomplish that?Thanks

Hello everybody:I'm new on cisco environment, I have a Nexus 5020 and a cisco router and a T1 and csu/cdu on my network.The design of my network will be ok with this graphic attempt ?? the type of connectors on the switches are ok ?? or I have to use...

Hi Dear allI have trouble in my  switch cisco 2950 series    24 port  , when I have more than 2 VLAN  and make No  shutdown for one the other VlAN is shutdown , I delete the old OIS and install  new IOS , the problem it stele, and when I put the STP ...

Suppose you have a switch with many vlans configured and that there is not inter-vlan routing configured.An access port on the switch is linked to a router.I imagine that the vlan of this access port become necessarily the only vlan through with I ca...

i have switch 2950 series  i install IOS Software (C2950-I6Q4L2-M), Version 12.1(22)EA13 , is that mean that the switch work now at layer 3 , and how can i enable the layer 3 in this switch and how can i show the taype of layer through command prompt...

   Hi Friends,Is there any option to get bandwith utilization of particular vlan. Pls guide meSetup:Enduser(Vlan13) in Access Switch 1 ----- > Core Switch (L3 & L2 Vlan 13) ---- > Internet Gateway --> Public Internet ---- Other end... (Sever) Thanks,...

I am having a problem configuring a 2811 with in WIC-2AM-V2 in slot 0.  The issue is not the basic setup.  The modem is responding to AT commands appropriately.  This issue is that the modem does not appear to be support Fax Class 2. When I query the...

Hello Friends,I have a very different requirement to be configured on the 24 port catalyst  switch. Switch details are given belowC2960-LANBASEK9-M, Version 12.2(53)SE1, RELEASE SOFTWARE (fc2).IP address assigned to users should not be used by others...

HiMy cisco 6513 running OS "s3223-advipservicesk9_wan-mz.122-33.SXI3.bin" rebooted autoatically and stuck in rommon mode and i am getting the below error in nvram ."nvlog_crash_hook:System crashed on slot 7. Checkvalue of Rommon variable CRASHINFO "W...