Buy or Renew
Buy or Renew

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

DHCP question on a Cisco 3750G stack

I am wondering if it is possible to assign a DHCP address range from the last switch only on a 3 switched stack, and how to do it ?. The reason I ask is that we want to VLAN off the third switch for a certain department and isolate them as much as po...

Resolved! Can we combine 2 interfaces on same router

Can we combine 2 interfaces on same router for redundancy purpose, like we do port channelling on switch.I know for redundancy on 2 layer3 device we can use routing protocols like HSRP,VRRP...Is there any way we can use 2 interfaces on router to assi...

QoS 2960

Dear Experts,Can you please guide me in knowing "What is the difference between QoS Features in 2960 & 3560 Switch". I am seeing all the features are present in both the switch models. 2960 also supports L3 Packets, Marking, Policing etc. I refered C...

Not getting Video from IP Camera on my LAN

Hi,I have a setup including Cisco 6509 with SUP720-3B as a Core Switch and Cisco 4507 with SUP II +10GE as HUB switches in redundent mode. We have created several L3 Vlans in the Core switch and allow them upto the Hub Switches as a L2 Vlans. There i...

rite2anil by • Level 1
  • 562 Views
  • 1 replies
  • 0 Helpful votes

Resolved! [OT] Help with interview questions

Hi,Firstly I'd like to apologise for posting to this forum, as I was unsure which one to post to.I've just been told that I can hire another network administrator, my problem is that I've never done or taken a network administration/engineering inter...

dan_track by • Level 1
  • 1722 Views
  • 8 replies
  • 0 Helpful votes

VSS-Dual Active Scenario

HiI have configured VSS with cat 6509 switches and is working fine.The VSL link is configured with 10G ports on Sup 720-10g card (5/4 & 5/5).when i was doing the testing for the dual active detection by removing both vsl links,the current active swit...

Resolved! l2-l3 redundancy with failover firewall

fw1-------------------fw2!                      !!                      !!                      !!                      !!                      !sw1-----sw5            sw2-------sw6! !                    ! !! !                    ! !! !--------------...

Dynagen on real Network

I have a problem with a dynamips/dynagen  topology.  I have build a real network based on 28xx Router. To complete the  plateform I have to connect a 7200 Cisco Router (using emulation because  I don't have materiel).  With different method I tri...

Load more