Switching

Hi,we use a WS-C4510R-E with several PoE blades.With "show power capabilities" we can check the used and available power of the complete chassis, with "show power module" we can check the used power of the modules.Does anybody know how we can get thi...

hi,on basically every 3750 stack in our network, if i tcpdump on any port, i will generally see tcp flows where neither the source nor destination is related to the machine upon which i'm tcpdump'ing.we generally use stacks of WS-C3750G-48TS, WS-C375...

Folks:I need to implement a load balancing solution pretty soon and I would like some ideas regarding topology, design and methodology.This is what I have:1.) Two 7600 Aggregation routers with 4500 L2 server farm switches hanging off of them in a loo...

Hi, I have a 6509 that will be used to power many non Cisco Phones. My concern are the power supplies in the unit. I based my calculations on the actual power draw of the phones (4.4W). The supplies are fine for this, my question is whether the 6509...

hi, not sure about the architecture of CIGESM, but can we configure trunking on its internal ports (i can see at the backplane ports gig 17-20 only)? i've configured gig0/5 as trunk and it's connected to an IBM blade server 5. we want to pass vlan 34...

On a 2960G switch, I attempt to upgrade image. TFTP server is reachable. Then I execute the command 'copy tftp flash'. I see the exclamation points. It terminates successfully. I do 'reload'. I noticed that the reload did not ask me to "save the conf...

Hi, I am getting this messages can some one help me trouble shootMay 22 05:28:47.535 EST: %C4K_EBM-4-HOSTFLAPPING: Host 00:21:A0:0E:94:B0 in vlan 2 is flapping between port Gi3/3 and port Gi3/14May 22 05:29:13.387 EST: %C4K_EBM-4-HOSTFLAPPING: Host 0...

Hi,Can any one guide me setting up the privillages for the username in router and switches in router we created the username and given the privillage to 15 which was fine having full access to configbut we need one more username to see only the runni...

Hi, I would like to know how those command work? I am not sure of undersatnd the meaning of it.accept-lifetime 00:00:00 Jan 1 2009 23:59:59 Dec 31 2009send-lifetime send-lifetime 00:00:00 Jan 1 2009 23:59:59 Dec 31 2009Thanks Regards

Dear experts,Is there a way to copy one port config to other port ? i mean seemthing like "copy port X to port Y".. That way the machine will copy the whole config of port X one by one to port Y.Thanks,Yosi :)

Hi allwhen I use the console session to my router, and make sure the logging on command is on, with debugging to the console, are all possible debugging options on when using the console? or do i need to type each individual debug option ?

Hi, My Cisco 6509 switch stops sending its logs to our syslog server for no apparent reason..For this to work again we need to delete the configuration using the no logging host... and rehabilitate the same configuration. After all it's ok.you have a...

We are having issues with our Equalogic SAN reporting Disk Latency Issues. Equalogic points to the switches which show no signs so far of any latency issue or drops. These are 3750E series switches with no routing, just switching and all data is goi...