Switching

will SPA-4XT-SERIAL support DB60?

HI , Welcome for All I am putting two series widely in my new network , which are 500 and 3500 series , but here I am getting confused to select the Interface Module , Should I opt GLC-SX-MM or WS-G5484Thanks Praveen 9212 506 503

Hi Guys,I have a two remote sites each running call manager express with one site having only a 4MG ADSL connection to the internet therefore leaving only 512k for upstream traffic. There is also a vpn tunnel between the two sites.Users are experienc...

Hi allI would like to start a thread on best practice configs for the lan, VTP , stp, port setups, vrrp,hsrp etc etc.Please share your thoughts on what these arethanksCarl

Trying to wrap my head around the Nexus Data Centre solution compared to other vendors. Anyone make any comparison with other vendors. Anyways, FEX cons below and wonder if it is true or am I misunderstand the CCO doc.1. FEX does not support local sw...

Hi ,Can you tell me if a 6506 Sup32 is capable to route IPV6 using EIGRP? (Is this a code issue?Also is a 4506 VI capable of routing IPV6 using EIGRP?Thanks in advance

Hi...Is it possible to create 4 VLAN's on a switch with 4 ISP's and also to have interVLAN for 4 VLAN's on same layer 3 switch 3560. If is it possible than what procedure should i follow to configure switch.

Dear sir, Please advise why we configure redundancy , mode sso but it appear as rpr and it shown standby cold ? by right it should show standby hot and mode sso. thanks and appreciation.

Hello,We currently have IP's from ARIN routed on our ISP's BGP. We provide them our IP subnet info and they put in their BGP and route them to our interface on their switches...Now we received our own ASN from ARIN and we want to migrate over to doin...

no nothing about them. Customer has them and is asking me if they can make it so you can connect the two switches together in such a way that you can get failover without having to rely on HP software

I have a 3550 switch which is in the egress path towards the Internet at my client site. I have only one VLAN configured with an IP address on the switch, and all traffic goes through this Gateway in and out of the network.When I run a traceroute fr...

I have a 2GB (2 x 1GB) Etherchannel configured on my WS-C3560G-48TS-S ports GI0/30-31 and would like to know if their are any switch hardware restrictions for that bandwidth? Should I build them on different groups of port. The etherchannel is conne...