04-20-2017 09:34 PM - edited 03-08-2019 10:17 AM
Hi,
vlan A and vlan b (wired)
the mac device from the vlan a cannot access vlan b ,
To get it done I should do the following on my distribution
interface Vlan100
ip address 10.10.10.1
ip pim sparse-mode
!
interface Vlan200
10.10.201
ip pim sparse-mode
!
Since it is using link local address , software switching will happen , this will cause cpu hike
How to solve this
Thanks
04-20-2017 10:30 PM
Hello!
Try to use command ip pim dense-mode on your VLANs
04-21-2017 01:09 AM
Hi,
sparse mode is recommended ?
Thanks
06-03-2017 08:27 AM
Hello,
To enable Bonjour service between VLAN A and B, you need to enable Service Discovery Gateway (SDG) feature. And you do not need Multicast for that purpose. Following is the simple configuration example:
service-routing mdns-sd
service-list mdns-sd ANY permit 1
!
interface range Vlan A - B
service-routing mdns-sd
service-policy ANY IN
service-policy ANY OUT
!
This enables Local Area SDG function. If you need Wide Area SDG function across Wired and Wireless or multiple networks/sites then you need to implement with APIC-EM controller solution:
http://www.cisco.com/c/en/us/td/docs/cloud-systems-management/application-policy-infrastructure-controller-enterprise-module/1-3-x/sd-bonjour/release_notes/b_sd_bonjour_rn_133x.html
thanks,
rahul.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide