04-09-2021 04:22 PM
I get constant boot fail on my 3850 switch how to recover and go into rommon or switch: mode? I pushed and held the mode button in front of the switch 15 and 60 seconds 20 diffent times and just the one amber light flickers. please help.
Solved! Go to Solution.
04-09-2021 05:00 PM
You should press the mode button until it says on the console that the button is pressed or to release it.
If that does not work then most likely the switch is totally dead.
Reconnect the power cord to the or the active switch. Within 15 seconds, press the Mode button while the System LED is still flashing green. Continue pressing the Mode button until all the system LEDs turn on and remain solid; then release the Mode button.
04-10-2021 02:20 AM
- If nothing at all can be seen on the console, the device is broken and needs to be RMA-ed. If you still have console output , then post screenshot or a console-trail from putty (e.g.)
M.
04-09-2021 05:00 PM
You should press the mode button until it says on the console that the button is pressed or to release it.
If that does not work then most likely the switch is totally dead.
Reconnect the power cord to the or the active switch. Within 15 seconds, press the Mode button while the System LED is still flashing green. Continue pressing the Mode button until all the system LEDs turn on and remain solid; then release the Mode button.
04-09-2021 10:55 PM
I already tried these fix actions, holding the mode button between 15 -20 seconds and no success, just one amber light blinks and console repeats boot fail over and over.
04-09-2021 05:39 PM
In ROMMON, post the complete output to the following commands:
dir flash: set
If the switch has boot into IOS-XE, post the complete output to the following commands:
sh version dir flash: sh boot sh post
04-09-2021 10:07 PM
unfortunately it's in constant boot fail, I cant get it to rommon or switch: to enter any commands.
04-09-2021 10:36 PM
- Is there anything (else) displayed in the console ?
M.
04-09-2021 10:38 PM
Just fail boot, and the one amber light flashes. that's it.
04-09-2021 10:40 PM
correction boot fail.
04-10-2021 02:20 AM
- If nothing at all can be seen on the console, the device is broken and needs to be RMA-ed. If you still have console output , then post screenshot or a console-trail from putty (e.g.)
M.
04-10-2021 07:02 AM
What can cause this to happen?
04-10-2021 03:54 AM
I am afraid it's the end for the switch. RMA og a new one.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide