Boot path on switch stack

[fgasimzade]

I have uploaded a new IOS on a 3750 stack. Stack consists of two switches, a master and a member.

I have configured the master's boot path with a newaly extracted IOS. But the thing is that the member switch is still configured with an old path and I can not change it. Will master switch upgrade the stack member after reload? Is there any way to manually configure member switch with a new boot path?

BOOT path-list : flash2:/c3750-advipservicesk9-tar.122-44.SE2/c3750-advips

rvicesk9-tar.122-44.SE2.bin

Config file : flash:/config.text

Private Config file : flash:/private-config.text

Enable Break : no

Manual Boot : no

HELPER path-list :

Auto upgrade : yes

-------------------

Switch 2

-------------------

BOOT path-list : flash:c3750-ipbase-mz.122-25.SEE3/c3750-ipbase-mz.122-25.

EE3.bin

Config file : flash:/config.text

Private Config file : flash:/private-config.text

Enable Break : no

Manual Boot : no

HELPER path-list :

Auto upgrade : no

[dinesh.das · Accepted solution]

I think auto upgrade is disable on switch 2, refer following link for IOS upgradation of stack.

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_example09186a00804799d7.shtml

[fgasimzade]

Thank you