C9200 configure problem

[w11dgod]

Dear all I'm having a trouble while I was configuring my switch

So I wanted to add up this line to my switch 

statistics packet protocol

but it kept pointing out that the statistics command had an error like below

(config-flow-monitor)#statistics packet protocol
                                       ^
% Invalid input detected at '^' marker.

version:17.06.05

model:cisco catalyst 9200 48p

[Kasun Bandara]

@w11dgod hi can you share the available command list in (config-flow-monitor)# prompt? using '?'

[w11dgod]

Hi I did use "?" to see if there's a statistic command but there's nothing about it, but the document below said that this command supports 17.X version 

https://www.cisco.com/c/en/us/td/docs/routers/ios/config/17-x/ntw-servs/b-network-services/m_fnf-egress-vrf.html

here's the result of after entering ? in config-flow-monitor

(config-flow-monitor)#?
accessTunnel Filter traffic from access tunnel
cache Configure Flow Cache parameters
default Set a command to its defaults
description Provide a description for this Flow Monitor
exit Exit from Flow Monitor configuration mode
exporter Add an Exporter to use to export records
no Negate a command or set its defaults
record Specify Flow Record to use to define Cache
skipouter Skip the outer header information

[Kasun Bandara · Accepted solution]

@w11dgod hi it seems like this is not supported in 9200 switches.

Command Reference, Cisco IOS XE Bengaluru 17.6.x (Catalyst 9200 Switches) - Index [Cisco Catalyst 9200 Series Switches] - Cisco

you are checking ASR router config guide.

[w11dgod]

Oops! Okay... did not notice that lol~

Thanks for the assistance!!!