01-18-2023 04:57 AM
I have a c9300T switch that I am trying to configure for the first time, and for some reason, the switch itself keeps going through this weird system loop that I have never seen before and does not allow me to make any input into the CLI. I was thinking of re-imaging the switch but wanted to figure out what was going on and why... Currently, these are the messages that were presented to me via the CLI:
Jan 18 12:45:2
Initializing Hardware......
System Bootstrap, Version 17.3.2r, RELEASE SOFTWARE (P)
Compiled Tue 08/25/2020 23:46:12.85 by rel
Current ROMMON image : Primary
Last reset cause : SoftwareReload
C9300-48T platform with 8388608 Kbytes of main memory
boot: attempting to boot from [flash:packages.conf]
boot: reading file packages.conf
#
###############################################################################################################################################################################################################################################################################################################################################################################################################################################################################
Jan 18 12:46:17.112: %BOOT-3-SY
Initializing Hardware......
System Bootstrap, Version 17.3.2r, RELEASE SOFTWARE (P)
Compiled Tue 08/25/2020 23:46:12.85 by rel
Current ROMMON image : Primary
Last reset cause : SoftwareReload
C9300-48T platform with 8388608 Kbytes of main memory
boot: attempting to boot from [flash:packages.conf]
boot: reading file packages.conf
#
###############################################################################################################################################################################################################################################################################################################################################################################################################################################################################
Any idea what may be going on here?
Solved! Go to Solution.
01-18-2023 01:29 PM
Break the boot cycle into ROMMON and do an emergency-install.
If this (mis)behaviour is still present then RMA the switch.
Good luck.
01-18-2023 05:24 AM - edited 01-18-2023 05:24 AM
Looks like somethign wrong while in transit.
get in to ROMMON, download from cisco 17.6.4 bin file, Copy to USB and try to boot from USB see if that able to bood, then you can install using that image ?
01-18-2023 01:29 PM
Break the boot cycle into ROMMON and do an emergency-install.
If this (mis)behaviour is still present then RMA the switch.
Good luck.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: