Can't connect Cisco Network Assistant to 2911 router

[huffmanj]

                   I am trying to connect  my Cisco 2911 router to my community in CNA.  I can see the routers on the topology map, but when I try to add to community I get an error message stating that the router is unreachable (Unable to connect).  I can ping device from ame client. I can view Device Properties for map (Device type: CISCO2911/K9). Telenet attempt to connect but we only use SSH for connectivity (the same as all of my switches that are connected to community).  2911 is listed as a supported router on Cisco site.

Any quesses what I am doing wrong?

Thanks in advance.

J

[Durga Prasad M.S · Accepted solution]

Hi,
You need to enable http for the cna to work.

http://kirkpbm.wordpress.com/2008/07/13/cisco-network-assistant-enabling-http-access/
Pls check above link for other detailed instructions.

Rgds/DP
Sent from Cisco Technical Support iPad App

[huffmanj]

that worked

thanks

J

[huffmanj]

Now router are part of community, but grayed out on front panel view. not that big of a deal but any suggestions?

Jeff