12-31-2012 09:28 AM - edited 03-07-2019 10:50 AM
I am trying to connect my Cisco 2911 router to my community in CNA. I can see the routers on the topology map, but when I try to add to community I get an error message stating that the router is unreachable (Unable to connect). I can ping device from ame client. I can view Device Properties for map (Device type: CISCO2911/K9). Telenet attempt to connect but we only use SSH for connectivity (the same as all of my switches that are connected to community). 2911 is listed as a supported router on Cisco site.
Any quesses what I am doing wrong?
Thanks in advance.
J
Solved! Go to Solution.
12-31-2012 06:38 PM
Hi,
You need to enable http for the cna to work.
http://kirkpbm.wordpress.com/2008/07/13/cisco-network-assistant-enabling-http-access/
Pls check above link for other detailed instructions.
Rgds/DP
Sent from Cisco Technical Support iPad App
12-31-2012 06:38 PM
Hi,
You need to enable http for the cna to work.
http://kirkpbm.wordpress.com/2008/07/13/cisco-network-assistant-enabling-http-access/
Pls check above link for other detailed instructions.
Rgds/DP
Sent from Cisco Technical Support iPad App
01-02-2013 11:58 AM
that worked
thanks
J
01-02-2013 12:21 PM
Now router are part of community, but grayed out on front panel view. not that big of a deal but any suggestions?
Jeff
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: