cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
645
Views
0
Helpful
1
Replies

Can't Ping Devices

mharing01
Level 1
Level 1
Cisco Switch
- vlan 1 "management" - ip address 192.168.1.254 255.255.255.0
- vlan 2 "students"
- vlan 3 "staff"
- default gateway 192.168.1.1
- int fa 0/1 - switchport mode access - switchport access vlan 1
- int fa 0/2 - switchport mode access - switchport access vlan 2 
- int fa 0/3 - switchport mode access - switchport access vlan 3 (Device 2)
- int fa 0/23 - switchport mode trunk - switchport trunk allowed vlan all - switchport trunk native vlan 1 (Aruba Switch to ge 0/0/23)
- int fa 0/24 - switchport mode trunk - switchport trunk allowed vlan all - switchport trunk native vlan 1 (Cisco Router)
 
Cisco Router
- vlan 1 "management"
- vlan 2 "students"
- vlan 3 "staff"
- int fa 0/0 - no shutdown
- int fa 0/0.1 - ip address 192.168.1.1 255.255.255.0 - Encapsulation Dot1q 1 native
- int fa 0/0.2 - ip address 192.168.2.1 255.255.255.0 - Encapsulation Dot1q 2
- int fa 0/0.3 - ip address 192.168.3.1 255.255.255.0 - Encapsulation Dot1q 3
 
Aruba Switch
- vlan 1 "management" - ip address 192.168.1.253 255.255.255.0
- vlan 2 "students"
- vlan 3 "staff"
- ip default-gateway 192.168.1.1
- int ge 0/0/0 - switchport mode access - switchport access vlan 1
- int ge 0/0/1 - switchport mode access - switchport access vlan 2 (Device 1)
- int ge 0/0/2 - switchport mode access - switchport access vlan 3
- int ge 0/0/23 - switchport mode trunk - switchport trunk allowed vlan all - switchport trunk native vlan 1 (Cisco Switch to fa 0/23)
 
 
Device 1 is on VLAN 2 (192.168.2.25) - plugged into Aruba switch (port ge 0/0/1)
Device 2 is on VLAN 3 (192.168.3.25) - plugged into Cisco switch (port fa 0/3)
 
Pings:
- from device 1 I cannot ping device 2 or Aruba switch
- from device 1 I can ping all three router interfaces and cisco switch
- from device 2 I cannot ping device 1 or Aruba switch
- from deviec 2 I can ping all three router interfaces and cisco switch
 
 
Not sure why I can't ping from device 1 to device 2, device 2 to device 1 or from either device to Aruba switch?
1 Reply 1

your configuration is quit good. Even I try in pack tracer, both devices are pinging each other. you should check the default gateways of both devices and trunk between switches are well. 

HTH

Kazim

Review Cisco Networking for a $25 gift card