Hi,
I have a strange behavior on a Catalyst 9200 (Running IOS-XE 16.12.4). In the log the following recurrent set of message prints out :
Feb 24 07:43:35.611: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/5: PD removed
Feb 24 07:43:36.602: %ILPOWER-5-DETECT: Interface Gi1/0/5: Power Device detected: IEEE PD
Feb 24 07:43:37.611: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/5: PD removed
Feb 24 07:43:37.614: %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/5: Power Controller reports power Imax error detected
As I understand it means the device plugged-in port Gi1/0/5 required more power than negociated, but where it comes tricky is there is no device attached the interface at all :
#show interfaces g1/0/5 status
Port Name Status Vlan Duplex Speed Type
Gi1/0/5 notconnect 162 auto auto 10/100/1000BaseTX
And the PoE operationnal state remains 'faulty' :
#show power inline g1/0/5 detail
Interface: Gi1/0/5
Inline Power Mode: auto
Operational status: faulty
Device Detected: no
Device Type: n/a
IEEE Class: n/a
Discovery mechanism used/configured: Ieee and Cisco
Police: off
Power Allocated
Admin Value: 30.0
Power drawn from the source: 0.0
Power available to the device: 0.0
Actual consumption
Measured at the port: 0.0
Maximum Power drawn by the device since powered on: 0.0
Absent Counter: 0
Over Current Counter: 0
Short Current Counter: 0
Invalid Signature Counter: 0
Power Denied Counter: 0
Power Negotiation Used: None
LLDP Power Negotiation --Sent to PD-- --Rcvd from PD--
Power Type: - -
Power Source: - -
Power Priority: - -
Requested Power(W): - -
Allocated Power(W): - -
Four-Pair PoE Supported: No
Spare Pair Power Enabled: No
Four-Pair PD Architecture: N/A
I assume the issue happened previously and the device was maybe moved to another port. I tried to shutdown/no shutdown the interface but it remains the same. Does anyone know how to get rid of these error messages which fill-up the logs.
Thanks for you help, regards, Vincent
