cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6340
Views
0
Helpful
1
Replies

Cisco 2960 RESET

darren849
Level 1
Level 1

                   I have a cisco 2960 that I seemed to have lost the password. Its just a test switch. I would like to know how to reset it to factory default. I have managed to get to a switch: prompt by holding in the small mode button on the front of the switch and pluging in the power but lost from here.

1 Reply 1

Ivan Shirshin
Cisco Employee
Cisco Employee

Hi Darren,

Run the follwing comands:

     
     flash_init

     load_helper
     dir flash:

     rename flash:config.text flash:config.old

     boot

Please see the following guide for thecomplete procedure:

http://www.cisco.com/en/US/products/hw/switches/ps628/products_password_recovery09186a0080094184.shtml

Kind Regards,
Ivan

**Please grade this post if you find it useful.

Kind Regards,
Ivan
Review Cisco Networking for a $25 gift card