cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
130
Views
0
Helpful
4
Replies
Highlighted
Beginner

Cisco 3750X Netflow

I am trying to configure netflow on a Cisco 3750X switch. I accepts the flow record, flow exporter, flow monitor and sampler but wont accept the flow monitor on an interface.

 

Config is below

flow record COLLECT-1
 description Record to monitor network traffic
 match ipv4 destination address
 collect counter bytes
 collect counter packets
!
flow exporter SOLARWINDS-1
 description To Solarwinds
 destination 10.1.1.1 (not the actual address)
 source Vlan2
 transport udp 2055
!
flow monitor MONITOR-1
 record COLLECT-1
 exporter SOLARWINDS-1
 cache timeout active 300
!
sampler SAMPLER-1
 mode random 1 out-of 32
!

 

I get the following response when I try to add the config to an interface

SW01(config)#int g1/0/48
SW01(config-if)#ip flow monitor MONITOR-1 sampler SAMPLER-1 input
% Flow Monitor: 'MONITOR-1' could not be added.
SW01(config-if)#

 

I have kept it simple as per the cisco config guide, am I missing something really obvious ?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Cisco 3750X Netflow

Do you have a service module C3KX-SM-10G ?

https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3750-x-series-switches/product_bulletin_c25-688868.html

 

It seems to be mandatory to export FNF.

 

You can use "sh inventory" to ckeck it.

 

Regards

4 REPLIES

Re: Cisco 3750X Netflow

Hi

 

There is some limitation to use flexible netflow on this platform :

Flexible NetFlow is supported only on the Catalyst 3750-X and 3560-X switch running the IP base or IP services feature set and equipped with the network services module. It is not supported on switches running the NPE or the LAN base image.

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/15-0_1_se/configuration/guide/3750xcg/swmnetflow.html

 

Which image are you running ?

 

Regards

Beginner

Re: Cisco 3750X Netflow

Hi

 

I'm running

WS-C3750X-48P 15.0(2)SE11 C3750E-UNIVERSALK9-M

License Level: ipbase
License Type: Permanent
Next reload license Level: ipbase

 

It's operating as a layer 3 switch so I assume it is equipped with the network services module.

 

Regards

Re: Cisco 3750X Netflow

Do you have a service module C3KX-SM-10G ?

https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3750-x-series-switches/product_bulletin_c25-688868.html

 

It seems to be mandatory to export FNF.

 

You can use "sh inventory" to ckeck it.

 

Regards

Beginner

Re: Cisco 3750X Netflow

It would appear not

 

C3KX-NM-1G

 

So I guess its a no to using Netflow.

 

Thanks very much for your assistance.

 

Regards

CreatePlease to create content
Ask the Expert- Firepower configuration & troubleshooting