cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
16594
Views
10
Helpful
2
Replies

Cisco 3850 stacking H/w Version mismatch

Kurt Warner
Level 1
Level 1

I have a failed cisco 3850. I got a new switch in and the IOS was lower than my current stack so i upgraded it . When i do a show ver the IOS looks right but when i do a show switch the H/W version are different.  This will cause my stack to fail ? 

New switch :
 
Switch Ports Model              SW Version        SW Image              Mode
------ ----- -----              ----------        ----------            ----
*    1 56    WS-C3850-48P       03.07.03E         cat3k_caa-universalk9 INSTALL
                                                                 
                                                                 H/W   Current
Switch#   Role    Mac Address     Priority Version  State
------------------------------------------------------------
*1       Active                                     15           V04     Ready
Old Switch :
Switch Ports Model              SW Version        SW Image              Mode
------ ----- -----              ----------        ----------            ----
*    1 56    WS-C3850-48P       03.07.03E         cat3k_caa-universalk9 INSTALL
S
                                                                  H/W   Current
Switch#   Role    Mac Address     Priority Version  State
------------------------------------------------------------
*1       Active                                      15     V06     Ready
1 Accepted Solution

Accepted Solutions

julijime
Cisco Employee
Cisco Employee

Hi Kurt,

That will not cause the stack to fail, you just need to make sure that the IOS version and the license level are the same between the stack members and make sure to power down the new switch before connecting it into the stack.

HTH

Julio

View solution in original post

2 Replies 2

julijime
Cisco Employee
Cisco Employee

Hi Kurt,

That will not cause the stack to fail, you just need to make sure that the IOS version and the license level are the same between the stack members and make sure to power down the new switch before connecting it into the stack.

HTH

Julio

BCCLTGIT30081
Level 1
Level 1

Hi 

I am observing the same issue in 3650 and due to this i am unable to change the priority of my stack.

Switch#sh switch
Switch/Stack Mac Address : 2cf8.9bff.6080 - Local Mac Address
Mac persistency wait time: Indefinite
H/W Current
Switch# Role Mac Address Priority Version State
-------------------------------------------------------------------------------------
*1 Active 2cf8.9bff.6080 1 V04 Ready
2 Standby e41f.7bbe.ed00 1 V06 Ready
 
 
Switch#
Switch#sh boo
Switch#sh boot
---------------------------
Switch 1
---------------------------
Current Boot Variables:
BOOT variable = flash:cat3k_caa-universalk9.16.09.06.SPA.bin;
 
Boot Variables on next reload:
BOOT variable = flash:cat3k_caa-universalk9.16.09.06.SPA.bin;
Manual Boot = no
Enable Break = no
Boot Mode = DEVICE
iPXE Timeout = 0
Switch#
Review Cisco Networking for a $25 gift card