05-08-2017 09:17 AM - edited 03-08-2019 10:29 AM
Hello,
Here is my network :
on Fastethernet 0 , my internal network with a dhcp pool 192.168.1.X on Vlan 1
I would like create a PPPOE connection based on fastehternet 3 and i would like to route FA0 to FA3 for internet request.
In attachment my tested configuration, but It doesn't work.
DO you have a exemple for this configuration?
Thank you
Regards,
05-09-2017 12:56 PM
Here is a very good example of configuration: http://pingbin.com/2014/09/cisco-887va-m-vdsl2-pppoe-configuration/ and other: http://ganomi.com/index.php/10-cisco-887va-configuration
Read it and if you have a question you can write me for help.
---Do not forget to rate useful post.---
Regards,
05-10-2017 03:29 AM
Hi
you need to add ip nat command under Dialer0
interface dialer0
ip nat outside
HTH
Hitesh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: