Cisco 9200L 24 4X10G VSS configuration

[IvanZabaluyev]

Dear community.

I am trying to find information about configuring VSS on 2 Cisco 9200L switches. And the last information, I found in the Cisco Community Forum was from 2017. And the information was not very good for me. As I found I can't configure VSS on these switches. But, technologies raise fast, and I wonder, is it possible to configure VSS on two 9200L switches now, with the most recent software version? If yes, please give me a URI (URL).

Thank you in advance

[inderdeeps]

@IvanZabaluyev : Well i think these switches are mainly for the Access and VSS is not supported in the Access, they support stacking 

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9200/software/release/17-5/configuration_guide/ha/b_175_stck_mgr_ha_9200_cg/managing_switch_stacks.html 

[balaji.bandi · Accepted solution]

Cat 9200 new switches are only Access switch, they can only be done Stacking switches.

https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-9200-series-switches/nb-06-stackwise-architecture-cte-en.html

VSS until 6500/ 6800 models only

Cat 9500 / Cat 9400 / Cat 9600 do Stackwise Virtual (replacement of VSS)