Cisco ASA routing guest VLAN

[jkay18041]

I am having some issues getting my guest VLAN to route through my Cisco ASA.

I've got port 4 setup with the IP of 192.168.100.1 and I want to use an IP in our public IP subnet of (example) 5.4.3.2/26 

I've got my switch setup to handle DHCP for the Guest VLAN and I'm using a ruckus controller.

So port 4 on the ASA is the only used for Guest VLAN 5. I can ping from a device connected on the wireless network 192.168.100.1 so I know traffic is getting to the ASA I'm assuming my NAT is setup wrong.

Any advice on how to get this working correctly?

Thank you

[Georg Pauwen · Accepted solution]

Hello,

post the full configuration of your ASA...

[Georg Pauwen]

Hello,

I don't see the attachment ?