11-05-2021 09:42 PM
I can connect with the switch by using console port. however it is asking the password.
can someone please advise how to overcome this?
how to do clear setting for the catalyst 1000 (C100-24T-4G-L)
Thank you,
11-05-2021 11:17 PM - edited 11-05-2021 11:19 PM
Hi,
is this new switch or old switch?
this will help if you are with same kind of scenario
rate and mark as answer if this helps
11-06-2021 01:21 AM
If the device new you need to quick setup guide :
If your device supports Bluetooth, it loads with the initial setup tasks preconfigured. Connect your PC to the device using Bluetooth. In your Web browser, enter the IP address 172.16.0.1. Enter the following default credentials: username: cisco, password: cisco and press Enter.
11-06-2021 02:18 AM
11-06-2021 02:29 AM
Do factory reset if there is no config :
11-06-2021 03:33 AM
11-06-2021 03:47 AM
Do factory reset if there is no config : https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst1000/hardware/installation/8_16_port_hig/b_c1000_8_16_hig/configuring_the_switch.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide