03-09-2020 08:37 PM
Hi Experts,
I have this weird issue on one of our switches Few ports are not working properly. When I plugged a computer on the port I always get "Unidentified Network"
These ports are 1,2.46 and 25 as far I've tested.
I already tried plugging in a laptop directly to the switch to make sure that it's not a faulty cable issue. And I get the same result, but when I tried plugging it in a different port in the same switch. I'm able to connect to the network/internet.
Also all ports have same config. Only port 50 is in trunk mode which is connected to the other switch.
Device Details:
1. Model - SG500-52
2. Firmware - 1.4.11.4
Please advise
Thank you.
03-10-2020 12:47 AM
- This might well be a 'local problem' on your PC. Check network settings/assigned IP/etc <-> compliance with your Intranet networking setup and addressing (e.g.).
M.
03-10-2020 09:31 AM
The original post asks whether this is likely a hardware issue or a software issue. We do not have enough information to know that. But my guess based on the little that we know is that it is more likely software than hardware. If this were a regular Catalyst switch I would look into the output of show interface status and of show vlan to investigate. I am not sure what the equivalent is on this platform.
03-10-2020 09:32 AM
You can try making the port to default configuration and disabling/enabling the POE.Also check the logg and show interface output to get more details.
03-10-2020 04:13 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide