Hi all,
I have issue with customer that said the module was faulty. Below is the error log that i received.
2021 Jan 3 09:01:49 SPMY-N7K-B-CORE %PLATFORM-2-MOD_DETECT: Module 10 detected
(Serial number JAF1424CAHJ) Module-Type 10 Gbps Ethernet Module Model N7K-M132XP
-12
2021 Jan 3 09:01:49 SPMY-N7K-B-CORE %PLATFORM-2-MOD_PWRUP: Module 10 powered up
(Serial number JAF1424CAHJ)
2021 Jan 3 09:01:49 SPMY-N7K-B-CORE %PLATFORM-5-MOD_STATUS: Module 10 current-s
tatus is MOD_STATUS_POWERED_UP
2021 Jan 3 09:02:11 SPMY-N7K-B-CORE %PLATFORM-2-MOD_PWRFAIL: Module 10 failed t
o power up (Serial number JAF1424CAHJ)
The module status is powered-dn
N7K-B-CORE# show module
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
2 48 10/100/1000 Mbps Ethernet Module N7K-M148GT-11 ok
5 0 Supervisor Module-1X N7K-SUP1 active *
6 0 Supervisor Module-1X N7K-SUP1 ha-standby
10 0 10 Gbps Ethernet Module powered-dn
Mod Power-Status Reason
--- ------------ ---------------------------
10 powered-dn Unable to power up card (Power_OK not set)
Mod Sw Hw
--- -------------- ------
2 6.2(24) 1.9
5 6.2(24) 1.6
6 6.2(24) 1.6
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
2 54-75-d0-c3-69-a8 to 54-75-d0-c3-69-db JAF1419BMDH
5 00-26-98-22-ca-58 to 00-26-98-22-ca-5f JAF1417DKJA
6 00-26-98-22-4b-e8 to 00-26-98-22-4b-ef JAF1417DBEM
Mod Online Diag Status
--- ------------------
2 Pass
5 Pass
6 Pass
Xbar Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
1 0 Fabric Module 1 N7K-C7010-FAB-1 ok
2 0 Fabric Module 1 N7K-C7010-FAB-1 ok
3 0 Fabric Module 1 N7K-C7010-FAB-1 ok
Please advise. thanks
