cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
700
Views
0
Helpful
8
Replies

Cisco Switch Blocking or Disabling Ports

dkujat
Level 1
Level 1
8 Replies 8

dkujat
Level 1
Level 1

Sorry the post didn't load, but my cisco switch keeps disabling ports during updates to the server. We get quarterly updates and ports go offline. Is there another way to stop this action from happening? We have a Cisco C-3850-nm-4-1G

The ports going shutdown mode, then what is the Logs show ? what is the reason of port shutdown

what is the configuration applied on that port

show run interface x/x

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

So the Cisco is the switch for our Bosch CCTV and when we push updates to the server my CCTV ports keep shutting down each time. 

Do you config any broadcast storm threshold?

I'm not an expert at Cisco, so I don't know what you mean. I'm looking to know if I will have to use a PuTTy each time updates occur or if there is a feature we can turn off. 

You can check by 

Show interface status 

See if the port is go to errdisable 

For strom check this

https://community.cisco.com/t5/switching/where-to-configure-storm-control/td-p/3414884

 

what is the configuration applied on that port

show run interface x/x

If you are not IT Expert - Contact your  IT network people to help you.  Until provide information not much help you get here.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Can you more elaborate please 

Review Cisco Networking for a $25 gift card