12-22-2023 08:53 AM
I have this problem, cisco switch catalyst 3850 keeps at boot looping, how can I recover?
12-22-2023 09:01 AM
Make sure you use the right baud rate to get working.
check boot recovery :
12-22-2023 11:25 AM
Hi there, I´m trying to run emergency-install from USBFLASH0: from rommon mode, but it shows up this error
any solutions?
12-22-2023 02:36 PM
take lower USB stick like 8GB and not (USB 3.0 - some may have issue) - make sure it format FAT.
If you like you can also try TFTP methods, best is USB
12-22-2023 03:43 PM
Find a Toshiba- or PNY-branded USB flash (<64 Gb).
Format to FAT16.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide