cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
251
Views
0
Helpful
4
Replies

CISCO SWITCH STACKING

fmugambi
Spotlight
Spotlight

Hello Team,

In need of help for cisco 3850 switch stacking concepts.

If have been running a single 3850 switch for sometime now, then bring in a new 3850 and stack it, are the configs synced automatically or there are configurations neeeded to be done?

What are the requirements for this setup?

Thank you.

4 Replies 4

@fmugambi you can connect new switch to existing switch using stack cables. it will be a new stack member and in configuration you can see new set of interfaces added. use #sh run or #sh int status, to check the interfaces. configurations will expand automatically.. make sure both switches have same OS version and use correct stack cabling method to connect.

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3850/hardware/installation/guide/b_c3850_hig/b_c3850_hig_chapter_010.html

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

Richard Pidcock