02-22-2014 03:55 PM - edited 03-07-2019 06:22 PM
Hello, we have a very old WS-C2980G-A that I'm trying to configure.
It says on the front it is Ethernet 10/100/1000, but when I see port speeds it only goes to 10/100 and 1000 is not an option in the IOS.
I've looked at the manual and its going over gigabit ethernet and flow control settings, but when I try to turn on flow control or make any changes, it says that feature is not available on this port. (
http://www.manualowl.com/m/Cisco/WS-C2980G-A/Manual/290635)
Does anyone know how to set up Gigabit Ethernet on these catalyst dinosaurs? It'd be much appreciated! Thank you!
Solved! Go to Solution.
02-22-2014 04:20 PM
I believe the access ports are 10/100 only but the uplink ports are triple speed, i. e. 10/100/1000.
02-22-2014 08:44 PM
Hi,
Leo is correct
From the data sheet:
The Catalyst 2980G-A features:
•Dedicated 80-port, 10/100 Mbps Ethernet and two-port, 1000BaseX Gigabit Ethernet with flexible media interfaces
link to data sheet:
http://www.cisco.com/en/US/products/hw/switches/ps606/products_data_sheet09186a0080092688.html
HTH
02-22-2014 04:20 PM
I believe the access ports are 10/100 only but the uplink ports are triple speed, i. e. 10/100/1000.
02-22-2014 08:44 PM
Hi,
Leo is correct
From the data sheet:
The Catalyst 2980G-A features:
•Dedicated 80-port, 10/100 Mbps Ethernet and two-port, 1000BaseX Gigabit Ethernet with flexible media interfaces
link to data sheet:
http://www.cisco.com/en/US/products/hw/switches/ps606/products_data_sheet09186a0080092688.html
HTH
02-24-2014 04:06 AM
Thanks guys!
02-24-2014 01:20 PM
Thanks for taking the time to rate our posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide