03-19-2024 12:40 PM
I am teying to configure VTP mode on access switch. But it doesnt allow me to configure. When i typ VTP its not giving any result or it giving incomplete command
03-19-2024 12:45 PM
what is SW ? what is IOS ver.?
MHM
03-19-2024 01:01 PM
check VTP configuration guide :
https://www.cisco.com/c/en/us/support/docs/lan-switching/vtp/98154-conf-vlan.html
Note : if you already have VTP Server you try to configure another VTP Server that create a issue - make sure check the guide lines before you enable VTP.
03-19-2024 05:16 PM
VTP server configured in core switch and trying to configure vyp client access swiych. Unfortunately its not taking vtp field
03-20-2024 02:29 PM
check this thread : for small business switches for VTP :
03-21-2024 07:18 AM
Finally VLAN is up and client getting IP from switch. But urfontunatley switch ip is not pinging from any other switch and switch not pinging core ip same as switch not pinging its default gateway. Any idea ?
03-21-2024 08:10 AM - edited 03-21-2024 08:44 AM
Can you post show run config for core and access switch?
03-21-2024 01:23 PM
You have enabled VLAN 1 SVI on access switch, but other VLANs 100, 102-105 which were allocated on trunk link were not found in running config. Please do check SVI configuration properly on both access and core switch.
03-19-2024 03:44 PM
What model switch are you using?
03-19-2024 05:13 PM
SGS-350
03-21-2024 05:19 PM
Acces switch cbs 350
03-19-2024 05:26 PM
Looks like VTP is not supported on that model switch , however you can use GVRP they almost the same technology.
03-19-2024 05:38 PM
Our core support VTP and we made VTP server. Should we configure gvrp on core and access ? How we can configure GVRP?
03-19-2024 05:27 PM
I have gone thorugh may search i found something that sgs 350 amd cbs 350 doesnot support VTP configuration. My question if its not suporting does it will sunchronize vlan from core ? By default which vtp mode cbs 350 and sgs 350 will act ?
03-19-2024 08:00 PM - edited 03-19-2024 09:42 PM
Hello ziyadps,
VTP is not supported by SG300 switches. VLAN propagation from Sg300 to Core Switch is not possible .GVRP concept is totally different compare with VTP. GVRP only send information about the VLANs to its neighboring switches(which supports GVRP).
However, you can setup GVRP between two same SGS-350 switches....Please go through the following link:
Best regards
******* If This Helps, Please Rate *******
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide