we bought a cisco 3945 router recently. i did the initial configuration and saving is using copy running-config startup-config. but it is not getting saved properly. whenever i restart the router, it asks for initial configuration. that is every time i have to give IP address and other configuration after i switch off and on the router.
There is a configuration-register that controls if the startup-config is loaded on startup or not. It's likely that the config is saved but not loadad. If this is the case, you can see your config with "show startup-config".
You can see the actual value of the config-register with "show version". You set the default-value with
Please rate and mark as an accepted solution if you have found any of the information provided useful. This then could assist others on these forums to find a valuable answer and broadens the community’s global network.