cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
11501
Views
0
Helpful
3
Replies

copy running-config startup-config not saving

ajeni0001
Level 1
Level 1

hi,

 we bought a  cisco 3945 router recently. i did the initial configuration and saving is using copy running-config startup-config. but it is not getting saved properly. whenever i restart the router, it asks for initial configuration. that is every time i have to give IP address and other configuration after i switch off and on the router.

kindly help me

thanks and regards

Jeni A

3 Replies 3

There is a configuration-register that controls if the startup-config is loaded on startup or not. It's likely that the config is saved but not loadad. If this is the case, you can see your config with "show startup-config".

You can see the actual value of the config-register with "show version". You set the default-value with

config-register 0x2102

 

More on this topic is found in the config-guides:

http://www.cisco.com/c/en/us/td/docs/routers/access/1900/software/configuration/guide/Software_Configuration/appendixDconfigreg.html

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/fundamentals/command/Cisco_IOS_Configuration_Fundamentals_Command_Reference/C_commands.html#wp5236362650

 

I also have this problem except mine is on a 3650. How do I go about changing this?

 

Thanks,

Hello

sh version
sh boot
sh flash:

 

res

Paul


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Review Cisco Networking for a $25 gift card