03-14-2022 05:39 AM
Hi,
Is Cross-Stack EtherChannel or LAG supported on Cisco Business Switches CBS350?
There is no info in: Configuring LAG Settings on a CBS250 or CBS350 Series Switch through the Command Line Interface (CLI)
Kind regards,
03-14-2022 05:47 AM
When you say Stack, they different switches Physically, but virtually 1 Switch right.
So i do not see any issue connecting in switch 1 and Sw2 port to other side on only 1 switch ?
or you looking something different ?
03-14-2022 05:53 AM
Case:
Two stacked CBS350 (SW1, SW2) connected to external Switch SW3:
SW1 - CBS350 - Link 1 - SW3
SW2 - CBS350 - Link 2 - SW3
Can we configure Link 1 and Link 2 as a EtherChannel / LAG - between CBS350 stack and external switch SW3?
M.
03-14-2022 05:58 AM - edited 03-14-2022 05:59 AM
You want to LAG or Stack ? ( Switch 3 will be stand alone different switch right ?)
yes i do not see any issue, that what normal most people do for resiliance if switch1 go down still switc2 can work right ?
as per information hope below example you looking to do : (this is for cat swtiches) - i am sure you like to do the same right ?
03-14-2022 06:13 AM
EtherChannel / LAG - between CBS350 stack (SW1 and SW2) and external switch SW3
M.
03-14-2022 06:37 AM - edited 03-14-2022 06:37 AM
yes technically that is duable. (do you see any issue ?)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide