We have a brand new (unpacked and powered on) 886VA router with IOS 15.1(2)T1 with license "advipservices" connected to the serial console and are trying to configure it.
The console prompt is "Router >". When we try to issue the "enable" command we were asked for a password. We have tried "cisco" (what the documentation says) and also no password (just pressed enter) and some other ones (admin, root, system, service, password, enable,...) but we where not able to go into "enable-mode" and always get a "Bad passwords" response.
Please, could some one be so kind to point us in the right direction, or to the right documentation, or just tell me the default enable password?
Thanks very much
Andreas