Dell San connectivity with switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-19-2013 11:14 AM - edited 03-07-2019 03:01 PM
Hello Experts,
I configured dell san and connected with switch port for iscsi traffic. On dell, I can see the mtu value is by default set 9000 so please confirm if I need to do some other configuration on switch apart of VLAN and port assignment in same. Please provide any doc in this reference, if any.
Thanks
Sent from Cisco Technical Support iPhone App
- Labels:
-
Other Switching

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-19-2013 11:25 AM
What type of switch do you have? You may need to enable jumbo frames...
HTH,
John
*** Please rate all useful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-19-2013 11:48 AM
Cisco 4948 Switch L3
Sent from Cisco Technical Support iPhone App

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-19-2013 12:25 PM
See if this post helps:
https://supportforums.cisco.com/thread/2066293
HTH,
John
*** Please rate all useful posts ***
