Disable QOS on cisco WS-C4506-E

[sathvik k v]

Hello,

I have a Cisco 4506-E series switch in my envirnoment running cat4500e-ipbasek9-mz.122-53.SG2.bin and would like to disable QOS. From the configuration guide i see "no qos" will achieve this but i'm not able to disable QOS using the same. Should i use any additonal keyword with no qos to get this working?

Switch(config)#no qos
% Incomplete command

Switch(config)#no qos ?
Global QoS configuration subcommands:
 

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/53SG/command/reference/cmdref/int_sess.html#wp1978372

-Sathvik

[vivek srivastava]

Its an interface level command. You need to go under each interface and then run "no qos". 

[sathvik k v]

Thank you Vivek.

I did try that , only option I see is no QoS trust device.

[rosaho]

Posts in this discussion have been modified  due to possible misconduct. Please refer to the CSC terms of use for more details. https://supportforums.cisco.com/document/29951/cisco-support-community-acceptable-use-agreement