05-20-2015 02:15 PM - edited 03-08-2019 12:06 AM
Hello,
I have a Cisco 4506-E series switch in my envirnoment running cat4500e-ipbasek9-mz.122-53.SG2.bin and would like to disable QOS. From the configuration guide i see "no qos" will achieve this but i'm not able to disable QOS using the same. Should i use any additonal keyword with no qos to get this working?
Switch(config)#no qos
% Incomplete command
Switch(config)#no qos ?
Global QoS configuration subcommands:
-Sathvik
05-20-2015 10:08 PM
Its an interface level command. You need to go under each interface and then run "no qos".
05-21-2015 02:37 AM
Thank you Vivek.
I did try that , only option I see is no QoS trust device.
06-19-2015 04:07 PM
Posts in this discussion have been modified due to possible misconduct. Please refer to the CSC terms of use for more details. https://supportforums.cisco.com/document/29951/cisco-support-community-acceptable-use-agreement |
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide