Does Cisco ISR 4331 router support etherchannel

[Nadeem Jan]

Hi, 

Can someone confirm that Cisco ISR 4331 router support ethernchannel, if yes then can we connect I SR Router 4331 with 2960-X stack switches (different member use for router connectivity). 

Reference document link will be highly appreciated. 

[Reza Sharifi]

Hi,

Yes, the ISR series support etherchannel. See figure 1 and 2 in this document:

http://www.cisco.com/c/dam/en/us/products/collateral/routers/3800-series-integrated-services-routers-isr/prod_white_paper0900aecd806f698a.pdf

HTH

[iswift]

Hi
The doc referenced above above is from 2007 and refers to the x800 series (1800/2800/3800), so does not relate to the ISR4k series.
There are definitely reasons to consult the correct documentation, as while I was looking on the same subject for ISR4k's I found a doc for x900 routers, stating neither PAgP or LACP were supported, but the ISR4300 series definitely supports LACP (or the command options at least are shown as available)
Ian

[M@xim0]

Have you verified if etherchannel is supported on ISR4K?

[ERIK S]

The ISR 4331 supports portchannels. I have multiple sub interfaces on my Portchannel.

[TPWODL]

Thanks for your reply.It will be helpful for us if you share some configuration or command reference as I am trying to connect one ISR 4431with Catalyst 9500 series stack wise by port-channel..