doing changes on random multiple interfaces on cat9300

[sandevsingh]

Hi folks,

I am writing a MOP, but do not have a cat9300 handy. Idea is to change the vlan on multiple random ports at the same time rather than going to the individual port. I know there is a range command that makes you select the port range, but that might not do for random ports across the stack members. 

In short, can i change the vlan for ports - 3/0/1, 4/0/10, 5/0/15,2/0/14... and so on (all random) in a single statement? 

[Reza Sharifi · Accepted solution]

Hi,

Yes, as long as they are stacked:

 example:

interface range gigabitEthernet 1/0/1 , gigabitEthernet 2/0/1 , etc...

HTH