09-22-2017 11:04 AM - edited 03-08-2019 12:08 PM
Hello,
We have a mulcitast server that is firewalled but does not pass multicast traffic from the firewall to the n5k switch. It only passes the mulitcast traffic when we take the multicast server off the firewall. I'm presuming this is so becasue igmp/pim is not enabled on that port-channel trunk link between the fw and n5k switch. How do I enable it?
Thank you
09-22-2017 04:08 PM
09-22-2017 04:11 PM
Thanks for the response. As far as the fw blocking multicast traffic, that's been verified that it does not. yes, IGMP is enabled on that vlan that we are expecting to see the mcast traffic.
09-22-2017 04:31 PM
09-22-2017 04:49 PM - edited 09-22-2017 04:51 PM
It's a palo alto firewall. When issuing that command, I don't see anything for that vlan. I think the reason I don't see anything is because that VLAN is not an svi defined vlan on that switch. the scope/addresses is defined on that fw.
09-22-2017 04:52 PM
09-22-2017 05:11 PM
yeah we did all that in the doc.
09-22-2017 05:17 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide