06-07-2023 03:32 PM
Hi I'm pretty new to network and was wondering is it possible to enable portfast on the usable ports in this topology. If can then please show me how to do it. Thanks!
Solved! Go to Solution.
06-07-2023 04:10 PM - edited 06-07-2023 04:19 PM
Hi
The command is as follow:
Altona_SW(config)#int Fa0/10
Altona_SW(config-if)#spanning-tree portfast
%Warning: portfast should only be enabled on ports connected to a single
host. Connecting hubs, concentrators, switches, bridges, etc... to this
interface when portfast is enabled, can cause temporary bridging loops.
Use with CAUTION
%Portfast has been configured on FastEthernet0/10 but will only
have effect when the interface is in a non-trunking mode.
Altona_SW(config-if)#
But the interface must be Access Interface, as you can see on the warning.
06-07-2023 04:10 PM - edited 06-07-2023 04:19 PM
Hi
The command is as follow:
Altona_SW(config)#int Fa0/10
Altona_SW(config-if)#spanning-tree portfast
%Warning: portfast should only be enabled on ports connected to a single
host. Connecting hubs, concentrators, switches, bridges, etc... to this
interface when portfast is enabled, can cause temporary bridging loops.
Use with CAUTION
%Portfast has been configured on FastEthernet0/10 but will only
have effect when the interface is in a non-trunking mode.
Altona_SW(config-if)#
But the interface must be Access Interface, as you can see on the warning.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide