06-28-2016 07:57 AM - last edited on 03-25-2019 04:39 PM by ciscomoderator
what is the default ether-channel load balancing method on Cisco switches or does it varies based on platforms? I couldn't find any document that says about the "default" method.
06-28-2016 08:01 AM
It varies based on platforms. For most small switches (3560, 3650, 3750, etc) it is usually source mac and for chassis based switches source IP based.
HTH
06-28-2016 08:06 AM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages wha2tsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
Default varies per platform.
Available hashing methods, also vary per platform.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide