cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2400
Views
33
Helpful
17
Replies

Flexible Netflow Issue

Rawa Salah
Level 1
Level 1

    HI ALL

Dears

please i can't run the configuration of Flexible Netflow on my switch , the comands are not availabe !!!

please help

Notice / find the following table my switch model and software

Switch Ports Model              SW Version            SW Image             

------ ----- -----              ----------            ----------           

*    1 30    WS-C3750X-24       12.2(55)SE5          C3750E-UNIVERSALK9-M

Model number                    : WS-C3750X-24T-E

PLEASE I NEED NETFLOW HELP ME TO RUN ON MY SWITCH

17 Replies 17

I would set it up in a lab and test it first, if possible.

Sounds like you have the correct Network Service Module and license.

Don Jacob
Level 1
Level 1

What sort of error is thrown when you type in Flexible NetFlow commands? Or does it not even accept the FNF commands?

Regards,
Don Jacob


NOTE: Please rate and close questions if you found any of the answers helpful.

Regards, Don Thomas Jacob http://www.solarwinds.com/netflow-traffic-analyzer.aspx Head Geek @ SolarWinds NOTE: Please rate and close questions if you found any of the answers helpful.

Rechecked. You will need a newer IOS version is what it looks like.

The minimal Cisco IOS Software release for the service module is 15.0(1)SE

. Older Cisco IOS Software revisions will not recognize the service module.

Source:

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3750-x-series-switches/white_paper_c11-691508.html

Regards,
Don Jacob

NOTE: Please rate and close questions if you found any of the answers helpful.

Regards, Don Thomas Jacob http://www.solarwinds.com/netflow-traffic-analyzer.aspx Head Geek @ SolarWinds NOTE: Please rate and close questions if you found any of the answers helpful.