06-10-2012 08:05 AM - edited 03-07-2019 07:10 AM
Hi, On 2921, how do you quite service-module session and get back to the router?
Solved! Go to Solution.
06-10-2012 08:30 AM
CTRL-SHIFT-6 then "x"
You won't see output when you hit the first three (ensure you hold them ask down at the same time). When you hit "x", you'll drop back to the router session.
Note the session to the service module will still be active in the background (use show session to see)...which means when you hit "enter" on an empty router line you'll return to the service module session. Use "disconnect #" (where # is the session number listed in show session) to close the connection.
Good luck!
Sent from Cisco Technical Support Android App
06-10-2012 08:30 AM
CTRL-SHIFT-6 then "x"
You won't see output when you hit the first three (ensure you hold them ask down at the same time). When you hit "x", you'll drop back to the router session.
Note the session to the service module will still be active in the background (use show session to see)...which means when you hit "enter" on an empty router line you'll return to the service module session. Use "disconnect #" (where # is the session number listed in show session) to close the connection.
Good luck!
Sent from Cisco Technical Support Android App
06-12-2012 08:08 AM
Thanks that helps!
One more question related. You would use service-module to access the EtherSwitch, how do you access the firewall then? Thanks.
06-13-2012 04:33 AM
Not sure about the firewall. Is that a specific module on your 2900? If you search the Cisco site for the part number, you'll likely find a configuration guide somewhere that would have the necessary commands. If you post the specific module here I'd be happy to help search.
Best regards,
Ed
04-16-2014 04:22 AM
thanks for the tip!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide